Nanoxia Deep Silence 6 Window Especificaciones descargar pdf (Pagina 18)

8. The Acve Air Chimney

The innovave Nanoxia Acve Air Chimney allows the easy dissipaon of hot air in case of a

heat buildup under the top cover: Once the Air Chimney is opened, the connected fans are

automacally acvated. When the Acve Air Chimney is closed, the fans are switched o

again.

8.1 Connecng the fans to the Acve Air Chimney

At the back of the motherboard tray, you can nd a circuit board to which you can connect up

to three fans. It is powered by a 3-pin Molex connector that is connected directly to the power

supply.

To connect fans to the Acve Air Chimney, rst you need to remove the right side panel (seen

from the front) and the top cover (see chapter 5.2). Next, connect the fans to connectors

labeled the F1, F2 and F3 on the circuit board.

Then put the cover back on the case. As a

last step, please connect the cable from the

switch of the Acve Air Chimney back to the

circuit board (see drawing).

FAN3 FAN2 FAN1

POWER

SWITCH

8.2 Operaon of the Acve Air Chimney

In order to open the Air Chimney, slid the dial to the “open” posion. This automacally

acvates the pre-installed case fans under the top cover. To close the Air Chimney simply slide

the tab back in the opposite posion. This will also deacvate the fans.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Nanoxia Deep Silence 6 Window Especificaciones Pagina 18