Nanoxia Deep Silence 6 Window Especificaciones descargar pdf (Pagina 13)

When you remove the top cover, proceed

cauously in order to not damage the

cables of the I/O-Panel and the Acve Air

Chimney. To remove the cover completely,

you need to remove the right side panel

and disconnect the cable to the board that

goes to the switch of the Acve Air

Chimney (see drawing).

FAN3 FAN2 FAN1

POWER

SWITCH

6. Fan assembly

Five 140 mm fans are pre-installed in your Deep Silence 6. You can mount up to twelve fans in

total.

We recommend the use of the 120 or 140 mm Nanoxia Deep Silence fans, available separately.

These are technically and visually equivalent to the factory-installed case fans and will work in

perfect harmony with the built-in fan control of your case.

You can, of course, connect the addional fans to the fan controller (see Chapter 7) or, where

applicable, to the Acve Air Chimney (see chapter 8).

All air intake openings of the Deep Silence 6 are equipped with easy to clean dust lters. We

recommend that you clean them on a regular basis.

6.1 Fans in the front

To switch the fans in the front or to clean

the dust lters, rst open the lower front

door. Next, open the “Easy Access Panel” by

pushing slightly on the le side of the panel

(picture 6A).

picture 6A

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

Nanoxia Deep Silence 6 Window Especificaciones Pagina 13