
EN
You can also, with the Chimney open, mount addional case fans or a water radiator below the
cover. In this case, both the fan and the case interior are opmally protected against dust and
spills.
Standard Equipment:
Front: 2 x 120 mm Nanoxia DS-fans (max. 1.300 rpm)
Rear : 1 x 140 mm Nanoxia DS-fans (max. 1.100 rpm)
Oponal Equipment:
Side: 1 x 140/120 mm fan
Boom: 1 x 120/140 mm fan (demounng of HDD-cage necessary)
Top cover*: 2 x 120/140 mm fans (open Air Chimney advised)
Watercooling-ready
The Nanoxia Deep Silence 1 can be congured for use as a water cooling system. Therefore you
can install 120 or 240 mm radiators or a compact water cooling soluon at either the front of
the case as well as under the top panel.
Top Panel*: 120/240 mm Radiator
The case cover has special, lateral fastening points which allow for installaon of a 120/240
mm radiator. Please note that - depending on the manufacturer - under certain circumstances
the overhead 5.25 inch drive bay may no longer be used when using a 240 mm radiator.
Front: 120/240 mm radiator
Behind the front panel, a 120 or 240 mm radiator can be mounted. Please note that the hard
drive cages must be removed for this - one of the cages may alternavely be mounted on the
housing boom (using the standard plasc holders).
Including the 5.25 inch to 3.5 inch adapter in the lower 5.25 inch bay, you can sll accommoda-
te up to four 2.5/3.5 inch HDD inside the case while installing a front radiator.
For an opmum cooling performance we recommend to select for the front radiator installa-
on. In this conguraon, the standard and adjustable Deep Silence fans can supply the radiator
directly with cooler air.
* In the overhead installaon of heat exchangers and / or case fans the Air Chimney should be open in order to
support an eecve escape of the waste heat.
05
Comentarios a estos manuales