Nanoxia Deep Silence 3 Especificaciones descargar pdf (Pagina 8)

4.1 Fans in the case front

To switch the fans in the front or to clean the dust lters, please remove the front panel by

holding the cutout at the boom and pull it towards you with a rm tug.

Next, remove the four screws with which the dust lter is connected to the front and take

it out.

Please be advised that the fans are screwed to the dust lter.

The front dust lter allows the installaon of either 2 x 120 mm or 1 x 140 mm fans.

Two 120 mm Deep Silence fans (1.300 rpm) are preinstalled.

4.2 Fans under the top cover

If you want to install addional fans at the top of the case, please remove the Nanoxia

VentCovers rst by removing the screws on the outside of the case. Next, hold the fans from

the inside and secure them to the top by fastening the screws from the outside.

Case fans installed at the top of the case should exhaust air out of the case (fan rear side

facing outwards).

4.3 Fans at the boom of the case

If you want to mount a 120 or 140 mm fan on

the case boom, you must remove the hard

drive cage mounng located at the boom.

The rail is aached with four screws to the

boom.

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Nanoxia Deep Silence 3 Especificaciones Pagina 8